Gullco 350 - Manual (Page 2)

SPECIFICATIONS
THE FOLLOWING INSTRUCTIONS AND SAFTEY WARNINGS MUST BE READ
BEFORE THIS EQUIPMENT IS CONNECTED AND PLACED INTO SERVICE
BEFORE CONNECTION:
ENSURE THAT SUPPLY VOLTAGE MATCHES THAT SHOWN ON RATING
PLATE
The Model 350 and the Model 350A are 350 Lbs. (159 kg) capacity electrode
stabilizing ovens used to maintain welding electrodes in their dry state or to dry
electrode which have absorbed moisture. The Model 350 operated on single phase
power with heat being supplied by a single element. The Model 350A connects to three
phase power with heat being supplied by two elements. The ovens are normally located
in a central storage area. They are complete with recessed controls, removable shelves,
full insulation pilot light and a heating system incorporating low watt density elements.
Temperature is thermostatically controlled. Nesting feet and sockets ensure safe, easy
stacking of up to four ovens.
Ensure adequate free space is provided around the ovens for safe loading and
unloading of the electrodes. Users should exercise caution when loading and unloading
the oven. Certain parts of the oven and the electrodes may reach temperatures
exceeding 550º F (288°C). All exposed body parts must be protected against accidental
contact with hot materials. Safety glasses, gloves, overalls, and protective footwear
must be worn when using the over. Hot electrodes must be unloaded into a suitable
container capable of withstanding the heat and of containing the load safely.
To minimize the risk of electrical shock the Model 350 and Model 350A
should not be exposed to rain or placed in a wet location. Liquids should not be placed
in the oven. The oven should be connected to a suitable, fused power supply using a
recognised connector. The oven must be properly earth grounded. Before performing
ensure it cannot be restored. To minimise the risk of fire do not place food, beverages
or other combustible items in the oven.
USING THE OVEN
The oven is loaded and unloaded via the front door. Avoid contact with hot
surfaces during this operating. The load should be distributing securely and evenly
within the oven to ensure even heating. The shelves may be removed to accommodate
larger loads if required.
PARTS LIST
MODEL 350 350A
CAPACITY 350 LBS / 159 kg 350 LBS / 159 kg
VOLTAGE
(SEE RATING PLATE) 110 OR 220 VAC, 1PH.,
50/60 HZ 220 OR 440 VAC,
50/ 60 HZ
WATTAGE 1500 WATTS 1500 WATTS
TEMPERATURE
RANGE 100-550º F.
38-288°C 100-550º F.
38-288ºC
WEIGHT 105 LBS (47.6 KG) 105 LBS (47.6 KG)
EXTERNAL
DIMENSIONS H-22”, W-22”, D--24½”,
H-559mm,W-559mm D-
622mm H-22”, W-22”, D--24½”,
H-559mm,W-559mm D-
622mm
INTERNAL
DIMENSIONS H-14”, W-16”, D-19”
H-355mm, W- 406mm, D-
482mm
H-14”, W-16”, D-19”
H-355mm, W- 406mm, D-
482mm
MODEL 350 350A
ELEMENT 110 VOLTS 1015 N/A
ELEMENT 220 VOLTS 1020 1015A
THERMOSTAT EA-5 D1
THERMOSTAT KNOB EA-5K D1K
PILOT LIGHT 110 VOLT 1010A1 N/A
PILOT LIGHT 220 VOLT 2010-A1 1090-G1
LINE CORD 10-LC N/A
THERMOMETER KIT T-23 T-23
SCHEMATIC MODEL 350
SCHEMATIC MODEL 350A