IBASE IPPC15B7-RE - Manual (Page 23)

Copyright © 2013 IBASE Technology Inc. All Rights Reserved.
15 IBASE Technology Inc.
USB Intel® NM10 PCH integrated USB 2.0 host controller:
1. 4 ports in the rear panel
2. 1 port via onboard Mini-PCIE
3. 2 ports via edge golden-finger for connecting with ID910
4. 1 ports via edge golden-finger for connecting with IP930
**Total 8 x USB 2.0 ports**
LPC I / O Nuvoton NCT6627UD [128-pin QFP, 14x14x1.4mm]
- COM #1 (RS232/422/485 jumper-less) support ring-in with power @500 mA
(selectable for 5V or 12V)
- COM #2 (RS232 only) support ring-in with power @500 mA (cable selectable
by pin#9 or pin#10 for 5V or 12V) via onboard pin-header
- COM #3(TTL for MCU usage) thru golden finger to expansion module
(ID910)
- COM #4 (TTL for daughter board usage) thru golden finger to expansion
module
[Hardware Monitor]
2x Thermal inputs; 2x Voltage monitoring
Expansion
Slot Mini PCI-e socket x 1, Full-sized type, reserved one mounting hole for
half-sized type, [USB device support]
Digital IO 2 in & 2 out with 5V Vcc 0.5A and GND
[thru edge connector @ 1x6 pins Terminal block type]
Connector type Dinkle ECH350R-06P
Edge
Connector VGA DB15 connector, DB9 1 for COM1
Digital I/O connector @ 1x6 pin type
RJ45 x2 for GbE LAN, USB 2.0 connector x 4 for USB1~4
Line-out microjack, Mic-in microjack x 1
Onboard
Header/Conn
ector 2 ports x SATA II
4-pin power connector x2 for SATA HDD
2x5-pin box header for COM #2
2x5-pin header for LPC (Debug purpose only)
Mini PCI-e(1x) connector [Full-sized]
5-pin box header for smart battery interface
2x2-pin power connector, 2x2-pin power vertical type connector
1x power button
Watchdog
Timer
Yes (256 segments, 0, 1, 2…255 sec/min)
Power
management
MSP430G2433
Power
Connector
+12V DC-in only for AT/ATX mode
RoHS Yes
Golden
Finger A. PCIE(x16) golden finger x 1 for connecting with IP930
Including the signals below:
- PCIe(1x) x1, PCI x1, COM(TTL) x1, USB 2.0 x 1
- 12V 4A power, 5V 2A, 3.3V 2A
**Each pin for PCI-express is 1A**
B. PCIE(8x) for ID910 board
- COM (TTL) x1, USB 2.0 x2, 24-bit LVDS, DVI x1
- Power button x1, Reset button x1, LED signal HDD x1
- Audio x1, Audio detect pin for AMP x1
- 12V 4A power, 5V 4A power, 3.3V 4A power
- SCI x1