Insinger I Series Food Waste Disposer - Manual (Page 15)

Insinger Machine Company 2005 Page 15
PARTS REPLACEMENT
(cxontinued)
MOTOR SEALS AND/OR MOTOR
1. Shut off main power disconnect.
2. Disconnect disposer from dishtable and waste line; remove floor mount and disconnect electric line feeding
motor.
3. Slide out disposer.
4. Remove rotor and sizing ring, as described on Page 14.
5. Series “I” and “N”: Remove four (4) motor bolts.
Series “I” and “N”: Turn disposer over resting base, especially sizing ring clamping surface, on wooden blocks.
6. Series “S” and “G”: Remove four (4) motor bolts and lift off motor.
Series “S” and “G”: Drive out the lip seal and cartridge seal; clean seal seating area.
Series “S” and “G”: Turn base over and set in the new lip seal (open side of seal facing up) and oil with SAE 30
oil.
7. Install cartridge seal.
A. Place light application of Permatex adhesive gasket sealant or equivalent in seal bore in base.
B. Fully immerse new cartridge seal in SAE 30 oil.
C Install new cartridge seal (rubber seal ring up), using installation tool (available separately) making sure seal
is fully seated in bore.
8. Turn base back onto the wooden blocks.
9. Clean motor shaft and oil shaft well with SEA 30 oil.
10. Slide motor back over seals and fasten motor. BE SURE motor is in same position as before for electrical
connections.
11. Turn base with motor back over and make sure rubber seal ring on cartridge seal is in place.
12. Re-install components, as listed on Page 14 and reconnect disposer.