Kemppi SF 52W - Manual (Page 16)

FastMig SF 52W, SF 53W
14
EN
2.6 Panel SF 52W and SF 53W setup parameters
Normal MIG welding Setup -parameters
Name of parameter
Name on
display
Parameter
values
Factory
setting
Description
Pre Gas Time PrG 0.0 – 9.9 s 0,0 s Pre gas time in seconds
Post Gas Time PoG 0.0 – 9.9 s Aut Post gas time in seconds or automatically
according to welding current (Aut)
Creep Start Cr OFF, on OFF Switch creep start on or off.
Creep Start Level CrE 10 – 170% 50% Percentage of wire feed speed:
10% slowed start
100% = no creep start function
170% accelerated start
Start Power StA -9 ... +9 0 Strength of start pulse
Post Current Time PoC -9 ... +9 0 Post current
Arc Voltage Ard OFF, on OFF on: Display shows arc voltage
OFF: Display shows pole voltage
Cable Length CAb std, 5 – 80m std Cable loss is calculated for optimal arc
control and for the Arc Voltage display
Synergic MIG -welding SETUP -parameters
Name of parameter
Name on
display
Parameter
values
Factory
setting
Description
Pre Gas Time PrG 0.0 – 9.9 s Syn Pre gas time in seconds or automatically
according to synergic welding program
(Syn)
Post Gas Time PoG 0.0 – 9.9 s Syn Post gas time in seconds or automatically
according to synergic welding program
(Syn)
Creep Start Cr OFF, on OFF Switch creep start on or off.
Creep Start Level CrE 10 – 170% 50% Percentage of wire feed speed:
10% slowed start
100% = no creep start function
170% accelerated start
Hot Start Level Hot -50 ... 75% 30% Percentage of welding power:
-50% cold and +75% hot
Hot Start 2T Time H2t 0.0 – 9.9 s 1.2 s The duration of the hot start in seconds in
2T mode
Crater Fill End Level CrL 10 – 250% 30% The welding power at the end of the crater
fill stage as a percentage of the welding
power preset value
Crater Fill Start Level CrS 10 – 250% 30% The welding power at the beginning of
the crater fill stage as a percentage of the
welding power preset value
Crater Fill Time CrT 0.0 – 9.9 s 2.0 s The duration of the crater fill stage in
seconds (only in 2T mode)
Wise Fusion On FUS OFF, on OFF Switch Wise Fusion on/off (only in 1-MIG)
Wise Fusion Percent FUP 10...60% 25% Percentage of Wise Fusion (only in 1-MIG)
Penetration Level PEn -30 ... +30% 0% Set the arc length where penetration
control begins (only in 1-MIG)
MiniLog On ML on, OFF OFF Switch on/off MiniLog
MiniLog Level MLo -99 ... +200% 50% Set the minilog power level as a
percentage of the welding power