La Crosse Technology WS-9630 User Manual
Page 2
6
1.
First, insert the batteries into the Temperature sensor. (see “Install and replace batteries in the
Temperature sensor“).
2.
Immediately after and within 30 seconds, insert the batteries into Weather station (see “Install and
replace batteries in the Weather station”). Once the batteries are in place, all segments of the
LCD will light up briefly. Following the time as 12:00 and the "Weather man" icon will be displayed.
If these are not displayed after 60 seconds, remove the batteries and wait for at least 10 seconds
before reinserting them.
3.
After inserting the batteries, the Weather station will start receiving data from the sensor. The
outdoor temperature and the signal reception icon should then be displayed on the Weather
station. If this does not happen after 3 minutes, the batteries will need to be removed from both
units and reset from step 1.
4.
In order to ensure sufficient 915 MHz transmission however, this should under good conditions be
a distance no more than 100 meters between the final position of the Weather Station and the
sensor (see notes on “Mounting” and “915 MHz Reception”).
Note:
x
If the signal reception is not successful on the first frequency (915MHz) for 45 seconds, the
frequency is changed to 920MHz and the learning is tried another 45 seconds. If still not successful
7
the reception is tried for 45 seconds on 910MHz. This will also be done for re-synchronization.
BATTERY INSTALLATION
INSTALL AND REPLACE BATTERIES IN THE WEATHER STATION
The Weather station uses 2 x AA, IEC LR6, 1.5V batteries. To install and
replace the batteries, please follow the steps below:
1.
Remove the cover at the back of the Weather station.
2.
Insert batteries observing the correct polarity (see marking).
3.
Replace compartment cover.
8
INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE SENSOR
The Temperature Sensor uses 2 x AA, IEC LR6, 1.5V batteries. To install and
replace the batteries, please follow the steps below:
1.
Remove the battery compartment cover at the back of the sensor.
2.
Insert the batteries, observing the correct polarity (see marking).
3.
Replace the battery compartment cover on the unit.
Note:
In the event of changing batteries in any of the units, all units need to be reset by following the setting up
procedures. This is because a random security code is assigned by the sensor at start-up and this code
must be received and stored by the Weather station in the first 3 minutes of power being supplied to it.
BATTERY CHANGE:
It is recommended to replace the batteries in all units regularly to ensure optimum accuracy of these units
(Battery life See Specifications below).
9
Please participate in the preservation of the environment. Return used batteries to an
authorised depot.
FUNCTION KEYS:
Weather station:
The weather station has four easy to use function keys.
SET key
IN key
+ key
OUT key
10
SET key
x
Press and hold the key to enter manual setting modes: Manual time, Calendar, 12/24 hour display
and Temperature unit °F/°C setting
+ key
x
To make adjustment for various settings
IN key
x
Press to display the MIN and MAX indoor temperature records
x
Press and hold to reset the indoor MIN/MAX temperature records
OUT key
x
Press to display the MIN and MAX outdoor temperature records
x
Press and hold to reset the outdoor MIN/MAX temperature records
11
LCD SCREEN AND SETTINGS:
Indoor Relative Humidity %
Weather
Tendency icon
Weather Forecast
icon (Weather
man)
Time
Outdoor Temperature
Outdoor Reception
Signal*
Indoor Temperature
Receiver Low Battery Indicator
Sensor low battery
indicator
Date
Indoor comfort indicator