Directed Electronics 3000 - Manual (Page 11)

8 © 2 0 0 5 d i re c t e d e l e c t ro n i c s , a l l r i g h t s re s e r v e d
disarming
To disarm the system, press . You will hear two chirps and the
parking lights will flash twice. If the siren chirps four times when disarm-
ing, refer to the Diagnostics section of this guide. This is called Tamper
Alert. If the siren is active (sounding) when the system is disarmed you
will hear three chirps but the system is not disarmed. (Refer to the
Remote Siren Silencing section of this guide.) However, if the alarm com-
pletes the full trigger cycle when disarmed you will hear four chirps.
disarming without a remote
This feature allows you to disarm the system without the remote should
it be lost, damaged, or disabled. In order to disarm without a remote,
you must have the motorcycle’s ignition key, know where the Valet
switch is located, and have the PIN code. Be sure to check with the
installer for the location of the Valet switch.
Turn the ignition On and then enter the PIN code as given in the fol-
lowing example to disarm without a remote.
1. Find the preset PIN code given in this manual.
FOR EXAMPLE: To disarm first enter a PIN code of 4301.
2. Turn the ignition On.
3. Press four times.
4. Then once. This enters the digit 4.
5. Then three times.
6. Then once. This enters the digit 3.
7. Then once. This enters a 0 as there was not a previous
digit entered with .