Daewoo SG-9210P - Manual (Page 35)

33
Connections and Copying
■ If you are using a SCART cable, select the AV input on the TV to see the picture from the player.
■ If you are not using a SCART cable, select the programme number on the TV reserved for video input
to see the picture from the player.
If you are not using a SCART cable, your player can transmit pictures and sound to the TV via the coax aerial
cable. Just tune the TV to the player's transmitting channel (factory set to UHF CH 52). Tune the TV carefully to
ensure the best pictures and sound.
Once you have carried out the steps in "Connecting up the player" , switch
on your TV.
Press the [ENTER] button of the player’s remote control for longer than 5
seconds to call up the player´s test signal.
Tune the TV to the test signal using the channel pre-set functions of your TV
as described in its manual.
When you have found the test signal, store it under the channel number on
your TV for player input.
Press the [ENTER] button of the player’s remote control again for longer
than 5 seconds to remove the test signal.
1
• If the quality of the test signal transmitted to the TV is poor due to
interference caused by a station transmitting on channel 52, you can tune
the player to a different transmitting channel. Find a free channel
between 21 and 69 on your TV.
Call up the player’s "SETUP" menu, choose "VCR SETUP" then "RF
OUTPUT SET".
Type in the free channel.
Store and exit.
2
• If the quality of the test signal transmitted to the TV is poor, fine-tuning on the TV may help
(refer to the TV manual).
• Without a scart cable, you will not get stereo sound from a TV capable of stereo sound.
RF OUTPUT SET
0-9:SELECT (21-69)
OK:CONFIRM SETUP:END
CH 52
To the TV via antenna cable (if you are not using a SCART cable)
VCR
Operation
DC-G8GD1P-JL (DESUK) 2006.4.19 9:42 AM ˘ ` 33