Measurement Computing CIO-DAC16-I - Manual (Page 8)

3.4 Cabling to the CIO-DAC##-I
The CIO-DAC##-I connector is accessible through the PC/AT expansion bracket.
The connector is a standard 37-pin D-type male connector. A mating female
connector, such as the C37FF-2, is available from Measurement Computing.
Several cabling and screw termination options are available from Measurement
Computing.
A screw terminal board that accepts spade lugs with
on-board area for prototyping circuitry. CIO-SPADE 50
4 X 16-in. screw terminal board with on-board
prototyping area. CIO-TERMINAL
37-position, 4 X 4-in. screw terminal board CIO-MINI37
5 foot shielded round cable with molded ends
housing 37-pin female connectors. Also in 10 ft. C37FFS-5
2 foot (and longer) ribbon cable with 37 pin D
female connectors C37FF-2
D connector, D shell and termination pins to
construct your own cable DFCON-37
3.5 Testing the Installation
You can test the installation of the CIO-DAC##-I using InstaCal. Select the Test
option to vary the output voltages and monitor them with a Volt Meter.
4