Measurement Computing Serial488/4 - Manual (Page 10)

Section 1 Introduction
Terminator:
 any 8 bit value
Handshaking:
 Clear to Send (CTS) / Request to Send (RTS), XON/XOFF, or none
I/O buffers:
 56,000 characters - dynamically allocated
Output Voltage:
 + 5 volts minimum (RS-232C); 5 volts typical (RS-422A)
Input Voltage:
 + 3.0 volts minimum: + 15 volts maximum
Connector:
 9-pin sub-D male.
IEEE 488
&$87,21
The IEEE 488 terminal must only be used to control a non-
isolated IEEE system. The common mode voltage (cable shell to
earth) must be zero.
Terminal Installation Category:
 Standard: Not Applicable.
 CE: Category 1.
Implementation:
 SH1, AH1, T6, TE8, L4, LE4, SR1, RL0, PP0, DC1, DT0, C0, E1
Terminators:
 Selectable CR, LF, LF-CR and CR-LF with EOI
Programmable:
 IEEE Terminators, Serial Terminator, EOI, SRQ Mas k, Data Port, Baud Rate,
Word Length, Parity, Stop Bits, Handshake Type, Handshake Control
Connector:
 Standard IEEE 488 connector with metric studs
1.3b