Montigo H38DF PFC - Manual (Page 23)

Page 23 XG0816 - 150204.1
H*38DF PFC Peninsula Gas Fireplace
Installation
Removing the door:
The H*38PF* doors are removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch the
door buckles and, remove the door. Replace in reverse order.
Figure 24a� Locate the door buckles. (Both Sides Typical)
Figure 24� Removing and installing the Horizontal Access Panel
Locate the Door Buckles: Step 2:
Step 1:
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushing away
from you and lifting out. Place
it aside during maintenance
or cleaning. Install in reverse
order.
Remove the Horizontal Access Pan el:
2
Step 5:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
the tool securely).
3
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
Figure 24d�
Figure 24e�
Front View
Door buckles
Small glass door
affixed to frame
with hardware.
Door Latch Hook
Door Latch Slot Hand-hold
Release the Door Buckles
Figure 24b. Door buckle Tool
1
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 24c�
Step 3:
Finger Holes
Installed Gas
Valve Cover
Section 8: Installing & Removing the Door
WARNING
When reinstalling door(s), always make sure all door
buckles are properly hooked and fully engaged.
4
Step 7:
Remove the tool from
the latch slot. Ensure the
latches are hanging freely,
the hook end is released
from the bottom of the door.
(Repeat all 4-steps for the
remaining latches).
Figure 24f�