PSE Archery Bow 2013 - Manual (Page 7)

COMPOUND BOW
USER’S GUIDE
7
Your Authorized PSE Dealer is supplied with technical information on PSE bows
and cams. Please see your Dealer for assistance when making these adjustments.
INSTALLATION OF ACCESSORIES
Arrowrest/Overdraw: The arrowrest or overdraw should be
installed according to the instructions received with the product.
It is usually mounted to the riser in the threaded hole on the
side opposite the shelf (Hole “A”) using the hardware provided
with the arrowrest or overdraw.
Sight: The sight should be installed according to the instructions
received with the product. It is usually mounted to the riser in
the threaded holes (Holes “B”) on the side opposite the shelf
using the hardware provided with the sight. Some bows are
equipped with multiple sight mounting holes which allow the
sight to be moved up or down.
Stabilizer: The stabilizer should be mounted according to the
manufacturer’s recommendation. It is usually mounted in the
threaded hole on the front of the riser (Hole “C”).
Bow Sling: The bow sling attaches to the riser of the bow
generally with the stabilizer. If a stabilizer is not used, attach the
sling to the riser with the correct sized bolt (5/16” - 24) using
the hole provided for the stabilizer (Hole “C”).
OTHER ADJUSTMENTS
Draw Weight: Your bow is factory-set to within 2 lbs.
of the peak draw weight indicated on the bow hang tag and the
last 2 digits of the serial number. Changes in draw weight can
be made by turning the limb bolt in or out. Before making any
changes in weight, turn the limb bolt clockwise to the bottom
position. Never use extreme torque when turning the bolt or
damage to the limb may occur. The limb bolt may then be
turned counterclockwise to obtain the desired weight, but NEVER
more than the number of turns indicated on the hang tag.
Adjust each limb exactly the same. (See note and Fig. A below)
Wheels/Cams: Many PSE wheels and cams have adjustable features. Each one comes from
the factory set up and ready to use but there may be occasions that you need to adjust the
characteristics of your bow. In some cases you will need a PSE Tune Chart to determine what
to adjust, and you may need to see a PSE Dealer for information. If you are not sure of the
adjustment you are making, stop and see your PSE Dealer for assistance. In many cases, an
appropriate bow press will be needed to make adjustments to cams and wheels. If you do not
have an appropriate press, see your PSE Dealer.
Hole
A
Holes
B
Hole
C
CAUTION: On some bow models,
the limb bolt locking screw, limb
support screws or pocket tang
locking screw MUST be loosened
BEFORE adjusting.
Pocket tang
locking screw
Limb
support
screw
Fig. A
Limb
bolt