Rena MACH X (Digital Color Label Printer) - Manual (Page 7)

SECTION 1
GETTING ACQUAINTED
1
SECTION 1 – Getting Acquainted
Front View
1. Top Cover – Provides access to the Print Engine.
2. Ink Tank Door – Provides access to the Ink Tanks and Service Station.
3. Winder Interface Port – Winder Interconnect Cord plugs in here.
4. Service Port – Provides advanced diagnostic access for service technicians.
5. Unwinder Interface Port – Unwinder Interconnect Cord plugs in here.
6. USB Port Connection – (USB 2.0) The USB cable attaches to the printer here.
7. Network Connection – (Ethernet) The network cable plugs in here.
8.
Main Power Switch, Receptacle and Fuse – Plug in AC power cord here. Switch turns main
power on or off. Fuse provides over-current protection. Fuse rating: 2.5A, 250V, slow blow.
CAUTION: Make sure power cord is disconnected from printer before checking/replacing fuse.
WARNING! Power-down the printer, using the ON/OFF button, before powering off the Main Power
Switch. If this power-down process is not followed; loss of settings, poor image quality and reduced
printhead life may result. Wait until all control panel lights turn off, before you turn off the main power
switch.