Scotsman SCR33 - Manual (Page 14)

Maintenance
Exterior Cleaning
Clean surfaces with a mild detergent and warm
water solution.
Do not use solvent-based or abrasive cleaners.
Use a soft sponge and rinse with clean water.
Wipe with a soft, clean towel to prevent water
spotting.
Interior Cleaning
Disconnect power to the unit.
Clean the interior and all removed components
using a mild nonabrasive detergent and warm
water solution applied with a soft sponge or
non-abrasive cloth.
Rinse the interior using a soft sponge and clean
water.
Do not use any solvent-based or abrasive cleaners.
These types of cleaners may transfer taste to the
interior products and damage or discolor the
interior.
Defrosting
Automatic Defrost
Frost on the rear wall is normal and will melt during
each off cycle.
If there is excessive build-up of 1/4” or more,
manually defrost the unit.
Ensure the door is closing and sealing properly.
High ambient temperature and excessive humidity
can also produce frost.
CAUTION
DO NOT use an ice pick or other sharp instrument
to help speed up defrosting. These instruments can
puncture the inner lining or damage the cooling
element. DO NOT use any type of heater to
defrost. Using a heater to speed up defrosting can
cause personal injury and damage to the inner
lining.
IMPORTANT
The drain pan was not designed to capture the
water created when manually defrosting. To
prevent water from overflowing the drain pan, place
towels or other absorbent materials over the
interior drain trough, under the evaporator (1),
before defrosting.
Manual Defrost:
1. Disconnect power to the unit.
2. Remove all products from the interior.
3. Prop the door in an open position (2 in. (5 cm)
minimum).
4. Allow the frost to melt naturally.
5. After the frost melts completely clean the interior
and all removed components. (See INTERIOR
CLEANING)
6. When the interior is dry, reconnect power and
turn unit on.
May 2011
Page 13
SCR33
User's Manual
1