Smithco Sand Star Zee (ZTR) 45-500-A Parts & Service Manual - Manual (Page 61)

59
Accessories
45-509 SCARIFIER PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-114 Digger Blades 9
2 HB-38-16-125 Bolt 3 /
8
- 16 x 1 1 /
4
9
HW-38 Washer 3 /
8
9
3 HNTL-38-16 Lock Nut 3 /
8
- 16 9
4 45-621 Attachment Lift Assembly 1
5 HB-12-13-150 Bolt 1 /
2
- 13 x 1 1 /
2
4
HNTL-12-13 Lock Nut 1 /
2
-13 4
6 45-599 Short Lift Strap (Ball field Application) 2
7 45-571 Long Lift Strap (Golf Course Application) 2
8 HCP-12-200 Clevis Pin 1 /
2
-20 2
HHP-18 Bridge Pin 1 /
8
2
INSTALLATION INSTRUCTIONS
1. Digger blades (Ref 1) should be bolted to the attachment lift (Ref 4) using the 3 /
8
hardware (Ref 2 and 3)
supplied.
2. Attach lift straps (Ref 6 or 7) to the attachment lift using 1 /
2
-13 bolts and lock nuts (Ref 5). Only tighten
enough so straps can move freely. If the attachment is being installed on a 45-500 Ball Field ZTR, use
the short lift straps. If the attachment is being installed on a 45-501 Golf Course ZTR, use the long
lift straps.
3. Using the 1 /
2
" clevis and bridge pin (Ref 8), attach the attachment lift assembly to the attachment mounts
on the main frame. Then connect the lift straps (Ref 6 or 7) to the arms of the attachment lift using 1 /
2
-13
bolts and lock nuts (Ref 5). Only tighten bolts until they until they will still rotate in the holes. DO NOT
OVERTIGHTEN.
TO LOWER SCARIFIER
1. Place detent pin in depth hole.
2. Push left pedal down.
3. Push lock arm inward (toward your leg) and release foot pedal slowly.
4. Lift rod will stop at detent pin.
TO LIFT SCARIFIER
1. Push foot pedal all the way down and lock arm, which is spring loaded, will spring into locking slot.
MORE PERMANENT DEPTH POSITION
CAUTION: DO NOT USE DURING TRANSPORT. DAMAGE COULD BE CAUSED TO SCARIFIER.
1. Push pedal down.
2. Push lock arm inward (toward your leg) and release foot pedal slowly.
3. Line up slot on lift rod with depth hole and place detent pin threw the selected hole and slot on the lift rod.
4. Scarifier will stay in that position until detent pin is removed.
5. To remove detent pin - apply pressure to he foot pedal, pull detent pin out. Push foot pedal to floor until
lock arm springs into locking slot.