Studio Technologies 76DA V.4.12 - Manual (Page 38)

Issue 9, May 2014 Model 76DA/77 User Guide
Page 38 Studio Technologies, Inc.
for Surround
Press and hold both the Surround/Stereo and Dim buttons for 5 seconds
to restore Model 77 factory defaults. Once defaults have been restored,
the associated LEDs will light. After the buttons are released, configuration
mode will be exited and normal operation will resume. See Note below.
Configuration—Restore Factory Defaults
Factory Defaults:
Device address A1.
Stereo input C sample rate converter enabled.
Post-fader stereo digital and analog monitor outputs can
be enabled.
Surround output bass management disabled.
Stereo output bass management disabled.
Bass management low-pass filter slope 24 dB/octave.
Bass management high-pass filter slope 24 dB/octave.
Bass management crossover frequency 80 Hz.
Mute/solo pre-bass management mode.
Sync source is L/R of currently selected input.
Sync input terminated.
Audio-synced-to-video sample rate 48 kHz.
Pre-fader surround/stereo input C direct digital monitor
output type balanced AES3 (110 ohms/5 Vpp).
Post-fader surround/stereo digital monitor output type
balanced AES3 (110 ohms/5 Vpp).
Reference level set for –60.0 dB post-fader monitor
output level.

Warning: Each Model 77 unit must have a unique address. Restoring factory defaults will reset only this specific
Model 77 to device address A1. If another connected unit is already configured for address A1, normal system
operation will stop.
Note: The 5-second button-press delay is a safety feature ensuring that the factory defaults will not be accidently
restored.
Attenuation display mode selected.
85.0 dB SPL reference level.
Auto reference level off disabled.
–20 dB dim level.
Remote mute all enabled.
Remote dim enabled.
L and R channel level change 0 dB when surround to
stereo downmix function active.
LS and RS channel level change –3 dB when surround to
stereo downmix function active.
C channel level change –6 dB when surround to stereo
downmix function active.
LFE level change full attenuation when surround to stereo
downmix function active.
Pre-fader surround digital monitor outputs pre-downmix.
6.0 dB channel pop solo up offset level.
–6.0 dB channel pop solo down offset level.
Input delay 0 ms for both A and B.
0.0 dB post-fader surround monitor output level offsets.
0.0 dB post-fader stereo monitor output level offsets.