X-Treme Audio X-ONE - Manual (Page 5)

User’s manual
XTODS XTODS
XTO XTO
XTODS XTODS
XTO XTO
11. System configurations
X-ONE loudspeaker systems can be used with analog controllers
which perform system specific equalization, crossover and limiter
functions. More complex set-ups will benefit from the use of
XTDT
amplifiers provided with a digital DSP. X-ONE systems can also
be used with
XTDP24 Digital Speaker Management System or any
other professional digital controller.
A system like this, operating with amplifiers having the power rating
suggested and used by experienced professional sound engineers,
is sufficiently protected from overdriving. For further information about
limiters threshold setting please refer to the controller’s user guide.
The nominal horizontal coverage pattern of XTO is 60-degrees. This
value is considered to be the optimum one in order to meet the re-
quirements of both small-and-medium size installations.
The crossover frequency recommended for XTOS subwoofers is
lower than 100 Hz.
X-ONE systems, driven by a properly configured controller, provide
an essentially flat on-axis frequency response. Equalizations to com-
pensate particular acoustic conditions of the environment can be
used if required. If the speakers are arrayed in several side by side
clusters, it is possible to obtain benefits from equalization correction
that offsets the effect of the sum of the mid-low frequencies caused
by the use of multiple loudspeaker systems.
Examples:
8 ohm configuration 4 ohm configuration
4-8 ohm configuration
5/6