HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 124)

124
4.3 The DIN PLUS Edit
o
r
4.3 The DIN PLUS Editor
Overview of main menu
The “Prog” pull-down menu (program management) contains the
following functions for NC main and subprograms:
„ Load existing NC programs
„ Create new NC programs
„ Save new or edited NC programs
The “Head” menu group (NC program header) contains functions for
editing
„ the program header
„ the turret assignment
„ the chucking table
With the “Geo” menu item (geometry) you can branch to
programming the workpiece blank or finished part contour. You select
either a workpiece blank or position the cursor to the BLANK or
FINISHED PART section and switch to the geometry menu.
The “Mach” menu item (machining) calls the submenu for
programming the machining. At the same time the CNC PILOT
positions the cursor to the MACHINING section.
The “Pab” menu item (program section code) calls a selection box
with section codes. It enables you to insert additional codes into your
NC program.
The “Block” menu group contains functions for marking and editing
groups of NC program blocks.
The NC Bl menu group contains
„ Functions for cursor positioning
„ Functions for numbering the NC blocks
„ Search functions
„ “Free editing” function
In the “Config” menu group configuration you can make the
following settings:
„ Switch-off/on the help graphic
„ Window configuration
„ Font size
„ In addition you can manage the settings”
In the “Graph” menu group you set the graphic window and activate/
deactivate the contour display.