HEIDENHAIN TNC 410 ISO Programming User Manual
Page 267
HEIDENHAIN TNC 410, TNC 426, TNC 430
241
8.4 Cy
cles f
o
r Mil
ling P
o
c
k
e
ts, St
ud
s an
d Slo
ts
U
U
U
U
Set-up clearance
Q200 (incremental value): Distance
between tool tip and workpiece surface.
U
U
U
U
Depth
Q201 (incremental value): Distance between
workpiece surface and bottom of pocket.
U
U
U
U
Feed rate for plunging
Q206: Traversing speed of
the tool in mm/min when moving to depth. If you are
plunge-cutting into the material, enter a value lower
than that defined in Q207.
U
U
U
U
Plunging depth
Q202 (incremental value): Infeed per
cut.
U
U
U
U
Feed rate for milling
Q207: Traversing speed of the
tool in mm/min while milling.
U
U
U
U
Workpiece surface coordinate
Q203 (absolute
value): Coordinate of the workpiece surface.
U
U
U
U
2nd set-up clearance
Q204 (incremental value):
Coordinate in the tool axis at which no collision
between tool and workpiece (clamping devices) can
occur.
U
U
U
U
Center in 1st axis
Q216 (absolute value): Center of
the pocket in the reference axis of the working plane.
U
U
U
U
Center in 2nd axis
Q217 (absolute value): Center of
the pocket in the minor axis of the working plane.
U
U
U
U
Workpiece blank diameter
Q222: Diameter of the
premachined pocket for calculating the pre-position.
Enter the workpiece blank diameter to be less than
the diameter of the finished part.
U
U
U
U
Finished part diameter
Q223: Diameter of the
finished pocket. Enter the diameter of the finished
part to be greater than the workpiece blank diameter.
Example: NC block
N42 G214 Q200=2 Q201=-20 Q206=150 Q202=5
Q207=500 Q203=+30 Q204=50 Q216=+50
Q217=+50 Q222=79 Q223=80 *