LeMond RevMaster Classic - Manual (Page 27)

Page 21
PARTS REMOVAL AND REPLACEMENT
post in the desired location and rotate the handlebar post adjustment
handle clockwise to secure the handlebar post.
Note: If the post will not slide all the way down you will need to
push the V- plunger back inside the frame tube.
7. Reinstall the handlebar.
PEDALS
1. Block the crank arm from spinning, and use a bicycle wrench on the
pedal nut to remove the pedal from the crank arm.
2. LEFT PEDAL: Turn the pedal nut clockwise and remove the pedal
from the pedal crank.
3. RIGHT PEDAL: Turn the pedal nut counterclockwise and remove
the pedal from the pedal crank.
4. Install the new pedal(s) by lightly greasing the pedal nut threads and
reversing steps 1-3.
PEDAL CRANK ARMS
Left Crank Arm
1. Using an 8-mm wrench, remove the crank arm bolt.
2. Thread a bicycle crank arm removal tool onto the crank arm shaft .
3. As you tighten the crank arm removal tool on the shaft, the crank arm
will pull off the crank arm shaft. Remove the crank arm form the
frame.
4. Apply a thin coat of grease on the bottom bracket spindle and align
the new crank arm 180° from the right crank arm and push the crank
arm onto the crank arm shaft.
5. Apply a thin coat of grease on the crank arm bolt. Install the crank
arm bolt and tighten to secure the crank arm. Rotate the pedals a few
revolutions and then tighten the crank arm bolt again to ensure that
the crank arm is tight.