Parkside PES 200 B1 - Manual (Page 34)

34 GB
Service centre / Warranty / Disposal Commissioning / Maintenance and cleaning / Service centre
Q Commissioning
Q Working Notices
Always work away from the body.
Hold the appliance with both hands (see Fig. B).
Introduce the attachment tool 4 to the material
or the area to be worked with the appliance
switched on. In that the working motion of the
appliance first takes place on contact with the
material, you will achieve a much more accu-
rate positioning of the attachment tool.
Q Switching ON / OFF
Notice: The working motion of the appliance first
takes place on material contact.
Switching on:
Push the ON / OFF switch / Stroke rate prese-
lector
1 forwards.
Switching off:
Push the ON / OFF switch / Stroke rate prese-
lector
1 backwards.
Q Selecting the stroke rate
Note: The optimal stroke rate is dependant on
the material or the surface to be worked. It is best
determined by simple trial and error. Always start
off with the lowest setting. Should the removal be
too slight, increase the stroke rate level for level.
Slide the ON / OFF switch / Stroke rate prese-
lector
1 to the front to increase the stroke rate.
Level 1: low stroke rate for precision work
Level 2: moderate stroke rate
Level 3: highest stroke rate for fast removal
Slide the ON / OFF switch / Stroke rate prese-
lector
1 to the rear to decrease the stroke rate.
Q Resharpening the
attachment tools
The best work results are only achieved with sharp
attachment tools. You should thus resharpen them
in good time.
RISK OF INJURy! Remove
the plug from the power socket before beginning
to sharpen the tools.
Place the attachment tool 4 to be sharpened
into the Electric scraper (see section on
“Changing attachments”).
On a belt sander (e.g. Parkside PBS 600 A1
see Fig. H):
Appropriately fasten the belt sander into / onto
a suitable stationary facility.
Pay attention to the running direction of the belt
on the belt sander when resharpening.
Q Maintenance and cleaning
Before you clean or maintain
the device always pull the mains lead out of the
mains socket.
Always keep the device clean, dry and free of
oil or grease.
Regularly clean the tool receptor 3 .
Clean the attachment tools of all remains of
adhesives and other grime.
Liquids may not be permitted to permeate into
the appliance.
Use a soft, fluff-free cloth to clean the housing.
Never use fuel, solvents or aggressive cleansers
that could damage plastic.
Q
Service centre
Have your device re-
paired only by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.