Epson Equity II - Manual (Page 18)

Connecting a Video Monitor
The Equity II has a built-in video interface for connecting a monitor.
The exact procedure you use to connect your monitor to the main unit
depends on the type of monitor you have. See your monitor manual for
detailed instructions or follow these general guidelines:
1. Place your monitor on top of or near the Equity II main unit. It is
easiest to connect the monitor cable if the back of the monitor and
the main unit face you.
2. If necessary, connect the monitor cable to the monitor. (Some moni-
tors come with permanently attached cables.)
3. If you have a TTL monochrome or RGB color monitor, connect the
appropriate end of the monitor cable to the direct-drive video port
on the back panel, as shown in Figure 1-6. If the plug has retaining
screws, tighten them with a screwdriver.
Figure 1-6. Connecting a monitor
11