Kichler 300146 - Manual (Page 9)

8
Fig. 15
Fig. 16
Light plate
Screws
Mounting ring
Bottom cover
mounting plate
Screws
Light plate
10. INSTALLING THE LIGHT PLATE
Step 1. Loosen the two screws on the
mounting ring attached to the motor shaft and
"remove" and save the third screw. (Fig. 15)
Step 2. Place the key hole slots on the light
plate over the two screws previously loosened
on the mounting ring.
Turn the light plate until is locks in place at the
narrow section of the key hole slots.
Tighten both key hole screws and replace the
third screw previously removed and tighten
securely.
11. INSTALLING THE BOTTOM COVER
MOUNTING PLATE
Step 1. Loosen the two mounting screws on
the inside of the light plate then remove and
save the third screw.
Step 2. Hold the bottom cover mounting plate
close to the light plate and place the key holes
on the bottom cover mounting plate over the 2
screws previously loosened from the light
plate, turn the bottom cover mounting plate
until it locks in place at the narrow section of
the key holes. Secure by tightening all three
screws. (Fig. 16)
Arkwright TM