Kichler 310105 - Manual (Page 9)

8
Fig. 15
Fig. 16
Light fixture mounting plate
Screws
Mounting ring
Light fixture
Screws
Light fixture
mounting plate Square wire connectors
Deckard TM
10. INSTALLING THE LIGHT FIXTURE
MOUNTING PLATE
11. INSTALLING THE LIGHT FIXURE
Step 1. Loosen the two screws on the
mounting ring attached to the motor shaft and
"remove" and save the third screw. (Fig. 15)
Step 2. Place the key hole slots on the light
plate over the two screws previously loosened
on the mounting ring.
Turn the light plate until is locks in place at the
narrow section of the key hole slots.
Tighten both key hole screws and replace the
third screw previously removed and tighten
securely.
Step 1. Loosen the two mounting screws on
the posts of the light fixture mounting plate
then remove and save the third screw.
Step 2. While holding the light fixture under
your ceiling fan, push the square wire
connectors together. One from the fan and
one from the light fixture. (Fig. 16)
NOTE: These connectors are color coded and
will ONLY engage when the colored strips are
matched (aligned).
Step 3. Tuck the connections neatly into the
light fixture mounting plate. Place the key
holes on the light fixture over the 2 screws
previously loosened from the light fixture
mounting plate, turn the light fixture until it
locks in place at the narrow section of the key
holes. Secure by tightening all three screws.
(Fig. 16)