Silvercrest SED 3.7 A1 - Manual (Page 12)

GB
IE
CY
10 SED 3.7 A1
Press the travel lock 3) 5 and slide the speed switch 6 upwards to
the desired speed level:
Level 1: for sensitive areas (armpits and bikini line) ―
Level 2: for legs ―
Hold the skin tight with one hand. 4)
Place the epilator perpendicular to the skin and, without exerting 5)
any pressure, move it against the direction of the hair growth.
Thereby, the side with the speed regulator 6 must face towards
you. Do not make back and forth or circular movements.
Always start anew and pass over the body part to be epilated
several times, so that all of the hair is removed.
NOTICE
It may be that the hair grows back after a few days. The ►
reason for this is that these hairs were too short to be
removed during the last epilation session.
When you are fi nished with the treatment, place the speed switch 6)
6 to “0”.
Clean the epilator head 7) 2 as described in the section “Cleaning
and Care”.
Replace the protective cap 8) 1 on the epilator head 2. Thereby,
ensure that the elongated depression on the protective cap lies
on the elongated elevation on the front of the appliance.
Otherwise, the cap does not hold correctly.
IB_71087_SED3.7A1_GB_IE_CY.indb 10 IB_71087_SED3.7A1_GB_IE_CY.indb 10 12.01.2012 10:43:26 Uhr 12.01.2012 10:43:26 Uhr