Meliconi GumBody Universal 3-300 - Manual (Page 2)

1. Turn on the appliance to be programmed:
- if a VCR, insert a cassette
- if a SAT or TER select a programme
- if a DVD insert a DVD.
2. Look in the Code Book for the brand of the appliance to
be programmed and make a note of the corresponding
code indicated alongside
(e.g. PHILIPS 0025).
3. Hold down the selection key for the appliance to be
programmed for 5 seconds.
4. When the key is released, it will start to flash. Enter the
brand code previously identified ( e.g. 0025). The selection
key flashes more quickly to indicate that the remote control
is ready for the search.
5. Point the remote control at the appliance. Press and slowly
release the ON/OFF key or PLAY for the VCR and DVD
several times, stopping when the appliance responds
correctly to the command.
6. When the appliance responds correctly, press OK to
confirm. Three flashes indicate that the search operation
has been completed correctly.
2
HOW TO PROGRAMME THE REMOTE CONTROL
F I T T I N G T H E BAT T E R I E S
Before programming and using the remote control,
fit the batteries.
The remote control requires 2 new AAA/LR03 batteries. Insert the batteries as shown:
• Change the batteries if the light indicator starts to flash
during use. The batteries are low.
• Make a note of the codes for your appliances on the
adhesive label inside the battery cover in case you have
to reprogramme your remote control.
• This remote control has a permanent memory and does
not lose the programmed codes or functions when the
batteries are removed.
To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
ADDITIONAL CHECK
Check that some of the other functions used on your original remote control are working correctly. If the
commands function incorrectly or erratically, you have probably entered a code for a similar remote control
but not the right one. In this case, repeat the search procedure starting from point 3, entering the code
previously used (e.g. 0025).
PHILIPS 0025
The TV - DVD - SAT keys can be programmed according to your
requirements, following the procedure described below.
The quickest and easiest way to programme the remote control is
by consulting enclosed CD or the website www.meliconi.com/guide .
Warning: programme one appliance at a time!
+ + +
5 SEC.
or
or
or