MINOURA Wheel Display Attachment 3 - Manual

Wheel Display Attachment
WA-3
instructions manual
(ver.1.0 2012/2)
- 1 -
Important Notices
• For displaying a pair of bicycle wheel set only. Do
not use for any other purpose.
• Fits 9mm quick release and standard nut type hub
axles. Any thru axle type hub is not compatible.
• When installing WA-3 on the pillar, you need to
disassemble the clamp and re-assemble it with
proper procedure. Follow the instructions below.
• The clamp is designed to fit the tube diameter
between 38mm (1-1/2") and 45mm (1-3/4"). When
installing on 43mm (1-5/8") or smaller diameter,
use the gray plastic shim in the clamp arms.
• When installing the wheel with 9mm quick release
skewer, the nut side must be put on the arm.
Opposite direction should give damage to the
acorn spring. Ideally, you should put a spacer
between the hub and the quick lever side for better
balance.
• Max load on WA-3 is 4 kgs.
How To Assemble
1
Wind the clamp arm
around the pillar.
Make sure that the
single-arm is located
the right side and the
double-arm is located
on the left side.
Install the supplied plastic
shim in the clamp only
when installing on 43mm
or smaller diameter pillar.
Make sure the parallel
ribs are located on the
single-arm side.
!
Pillar
(larger
diameter)
Put the shim
2
Put the Pivot Pin through all
three (3) holes of the clamp from
the bottom.
Screw the Pivot Pin Fixing Screw
with a flat washer into the pin.
!
If you have put the Pivot
Pin from top side, you
will not be able to screw
it with a hex wrench.
!
Do not firmly tighten
the Pivot Pin Fixing
Screw yet, otherwise the
next step will become
difficult.
The following explanation focuses on the clamp only,
so we don't show the attachments here.
Required Tools: 1 x M5 Hex Wrench
Pivot Pin Fixing Screw
Flat Washer
Pivot Pin
Clamp Tightening
Screw
Clamp Body
Once disassemble the
clamp to remove Pivot
Pin, Pivot Pin Fixing
Screw and Clamp
Tightening Screw,
then opne the clamp
arm.
3
Pillar
(smaller
diameter)