Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 39)

LSI Corporation
- 39 -
6Gb/s MegaRAID SAS RAID Controllers User Guide
August 2013
MegaRAID SAS RAID Controller Characteristics
6Gb/s MegaRAID SAS RAID Controller Family
3.1.4 MegaRAID SAS 9265 RAID Controllers
The 6Gb/s MegaRAID SAS 9265-8i low-profile SAS/SATA RAID controller controls eight internal SAS/SATA ports
through two SFF-8087 x4 internal mini SAS connectors.
The 6Gb/s MegaRAID SAS 9265CV-8i low-profile SAS/SATA RAID controller controls eight internal SAS/SATA ports
through two SFF-8087 x4 internal mini SAS connectors. This controller supports a Cache Vault Flash Module, CVFM03,
that connects to a CVPM02 module to provide backup for your data in case of power loss.
3.1.4.1 MegaRAID SAS 9265-8i RAID Controller – Board Layout and Jumper/Connector Information
This subsection provides the board layout, and the connector and jumper information for the MegaRAID SAS 9265-8i
RAID controller. The following figure shows the location of the jumpers and the connectors on the MegaRAID SAS
9265-8i RAID controller. The jumpers are set at the factory, and you usually do not need to change them.
Figure 14 Card Layout for the MegaRAID SAS 9265-8i RAID Controller
NOTE Pin 1 on the headers and connectors is highlighted in red in this figure.
85079-00
J2B1 J2B2
J1A1
J1A2
J1A3
J1A4
J1A5
J1A7
J2B3
J2B4
J5B1
J5A1 J6A1