Avago Technologies Syncro 9361-8i - Manual (Page 24)

Avago Technologies
- 24 -
Syncro CS 9361-8i and Syncro CS 9380-8e Controllers User Guide
November 2014 Chapter 2: Hardware and Software Setup
Syncro CS 9380-8e Two-Server Cluster Hardware Setup
6. Perform the following steps to attach the clip to a BBU-BRACKET-05 remote mount board.
a. With the remote mount board on a flat, clean, static-free surface, ground yourself, and make sure that the
system is grounded.
b. Remove the mounting clip and the remote mount board module from the package.
c. Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.
d. Hold the clip so the screw holes on the clip line up with the screw holes on the remote mount board, as
shown in the following figure.
e. Secure the clip to the three screw holes with the screws and the nuts.
The screws thread through the front of the clip and the remote mount board.
NOTE Center the screwdriver carefully to avoid stripping the screw heads. Do
not over-tighten the screws.
Figure 11 Installing the Clip on the Remote Mount Board
A
A
A
Clip
3_00895b-00