Sony UWP-D27 2-Person Camera-Mount Wireless Omni Lavalier Microphone System (UC90: 941 to 960 MHz) - Manual (Page 346)

Help Guide
Interchangeable Lens Digital Camera
ILCE-7C α7C
Controlling the camera using a smartphone (NFC One-touch remote)
You can connect this product to an NFC-enabled smartphone by touching them together and then operate the product
using the smartphone.
Make sure that [Ctrl w/ Smartphone] is set to [On] by selecting MENU →
(Network) → [Ctrl w/ Smartphone].
About “NFC”
NFC is a technology that enables short-range wireless communication between various devices, such as mobile phones
or IC tags, etc. NFC makes data communication simpler with just a touch on the designated touch-point.
NFC (Near Field Communication) is an international standard of short-range wireless communication technology.
Note
If you cannot make a connection, do as the following:
Launch Imaging Edge Mobile on your smartphone, and then move the smartphone slowly toward the (N-Mark) of this
product.
If the smartphone is in a case, remove it.
If the product is in a case, remove it.
Check whether the NFC function is activated on your smartphone.
Radio wave interference may occur as Bluetooth communications and Wi-Fi (2.4 GHz) communications use the same frequency
band. If your Wi-Fi connection is unstable, it may be improved by turning off the Bluetooth function of the smartphone. If you do
this, the location information link function is not available.
Activate the NFC function of the smartphone.
On an iPhone, launch Imaging Edge Mobile, and then select [Connect with the camera through One-touch
(NFC)] under [Connect with a new camera].
1
Switch this product to shooting mode.
The NFC function is available only when the (N-Mark) is displayed on the screen.
2
Keep touching the smartphone to the camera for 1 to 2 seconds.
The smartphone and the camera are connected.
You can shoot an image via remote control while checking the composition of the image on the Imaging Edge
Mobile screen.
3
346