HyperX Armada 27 27" 1440p HDR 165 Hz Gaming Monitor - Manual (Page 26)

HyperX Armada 27 QHD Gaming Monitor
Page 25 of 29
Issue Possible cause Solution
“OSD Lockout” is
displayed. The monitor's OSD Lockout
function is enabled. Press and hold the center of the
joystick control button for 10 seconds
to disable the OSD Lockout function.
“Power Button Lockout” is
displayed. The monitor's Power Button
Lockout feature is enabled. Press and hold the Power button for
10 seconds to unlock the power
button function.
Button lockouts
The button lockout function is available only when the monitor is on, an active signal is displayed, and
the OSD menu is closed. Holding down the power button or Menu button for 10 seconds disables that
button. You can re-enable the button by holding it down again for 10 seconds.
Questions or Setup Issues?
Contact the HyperX support team at: hyperx.gg/support .
Maintaining the monitor
Properly maintained, your monitor can run for many years. These instructions provide steps you can
perform to keep your monitor in the best condition.
Maintenance guidelines
Follow these instructions to enhance the performance and extend the life of the monitor.
● Do not open the monitor cabinet or attempt to service this product yourself. Adjust only those
controls that are covered in the operating instructions. If the monitor is not operating properly or has
been dropped or damaged, contact an authorized HP dealer, reseller, or service provider.
● Use only a power source and connection appropriate for this monitor, as indicated on the label or
back plate of the monitor.
● Be sure that the total ampere rating of the products connected to the outlet does not exceed the
current rating of the AC outlet and that the total ampere rating of the products connected to the cord
does not exceed the rating of the cord. Look on the power label to determine the ampere rating
(AMPS or A) for each device.
● Install the monitor near an outlet that you can easily reach. Disconnect the monitor by grasping the
plug firmly and pulling it from the outlet. Never disconnect the monitor by pulling the cord.