Epson Y465ss127mo - Manual (Page 84)

LINE FEED: This setting should remain at its default value
f f ) in most cases. Most applications send automatic line feeds at
the end of every line. If all of the lines are printing on top of each
other, then set LINE FEED to
DC 1 This setting should also be left at its default value
(Disable) in most cases. See these codes in Chapter 8 for more
information.
This setting controls which macro is loaded when
you turn on the printer.
To change and save the default settings, perform the steps listed below.
The following example describes the procedure for changing the
interface, baud rate, and parity for a serial interface, but all the other
options can be changed in the same manner. If you are changing only
one option, follow steps 1 4 and 13 17 only.
The displays shown may be different if your printer’s preset settings have
been changed.
Note: Your new default settings do not take effect until you turn the
printer off and then back on.
1. Select the mode from the SelecType main menu.
The display shows:
2. Activate this mode by pressing the button directly beneath the
display.
The display changes to: Parallel
Note: If you wish to change an option other than press
the or button.
3-20 Using the Printer