Electrolux 55750 - Manual (Page 28)

Installation
• Stick on the damp protection film as described in
the instructions on the rear side of the film (shorten
where necessary).
• Attach the side rails to the side panels of the furniĆ
ture as described in the separate assembly instrucĆ
tions.
• Place the appliance in front of the high cupboard,
and run the cable and hoses through the high cupĆ
board's bay so that they are neither kinked or squasĆ
hed.
• Align the dishwasher in the centre of the bay and
flush with the side panels, and where necessary, adĆ
just to be flush at the front surface using shims.
• Carefully open the door of the appliance without
changing the settings of the appliance.
• Using the pre-drilled holes, screw the appliance to
the side panels of the furniture on both sides in the
upper inner area (see Detail A).
• Before screwing the appliance diagonally through
the base plate using two additional screws (always
pre-drill), it is advisable to protect the appliance
door from damage using suitable materials (e.g. the
cardboard packaging). In order to tighten these
screws, the door must be opened by approx. 45 deĆ
grees (see Detail B).
Technical Data
Dimensions
Height 75.9 cm
Depth 57.0 cm
Width 54.6 cm
Capacity 12 place settings
Electrical connection 230-240V ć 50Hz
Motor rating during wash 140 W
Power of heating element 2000 W
Overall power 2150 W
Water supply pressure Minimum 1bar
Maximum 10 bar
153 0409 20 / 09.99
AEG
Detail A
Detail B