Panasonic Lumix GH5S Mirrorless Camera User Manual
Page 353
353
12. Others
[Unable to record AVCHD video. The selected system frequency does not match
the AVCHD data on this SD card. Please use another SD card or change the system
frequency.]
• If you continue to use the same card after changing [System Frequency]
, motion
pictures may not be recorded. To record with the same card, reset [System Frequency] to the
original setting. To record motion pictures with the current setting, try the following:
– Perform formatting
on this unit after saving necessary data on a PC, etc.
– Insert a different card.
[Recording was cancelled due to the limitation of the writing speed of the card]
• Depending on the [Rec Format] and [Rec Quality] of a motion picture, the speed class rating
required for the card differs. 4K photo recording requires a card that meets a particular speed
class rating. Use a card that meets the rating.
• If the recording stops even when you are using a card that meets the speed class rating, the
data writing speed is too slow. We recommend making a backup and then format the card
.
Depending on the type of the card, recording may stop in the middle.
[A folder cannot be created]
• A folder cannot be created because there are no remaining folder numbers that can be used.
Format the card on this unit after saving necessary data on a PC etc.
If you execute [No.Reset] in the [Setup] menu after formatting, the folder number is reset to
100.
[This battery cannot be used]
• Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or Panasonic.
• If the battery terminal is dirty, clean it and remove any objects.
[Failed to connect wireless access point]/[Connection failed]/[No destination
found]
• The wireless access point information set on this unit is wrong.
Check the authentication type and encryption key.
• Radio waves from other devices may block the connection to a wireless access point.
Check the status of other devices that are connected to the wireless access point as well as
the status of other wireless devices.