Jumper, Transfer speed switching, Dm-d110 – Epson DM D110 User Manual
Page 13
DM-D110/D210 User’s Manual 7
English
Transfer Speed Switching
*1 Default Setting
*2 Setting that is used when connecting to the USB model of the EPSON TM printer.
Jumper
There are jumpers in the stand (DP-110/210) that configure whether a TM printer
is connected to the DM-D110/210.
CAUTION:
Turn the power off before changing the jumper settings. Changing the jumper
settings while the power is turned on may damage the device.
Use the following procedure to change the jumper settings.
1.
Turn off the power switch; then remove the power cable from the stand.
2.
Remove the plate from the base of the stand. For the DM-D110, press the two
clips while lifting out the plate to remove the plate (see Illustration M). For
the DM-D210, remove the two screws to remove the plate.
3.
Change the jumper settings.
4.
Attach the plate. For the DM-D110, press down on the plate until it latches
into the clips on the stand (see Illustration N).
DM-D110
See Illustration C for the location of the jumpers.
SW1-5
SW1-6
SW1-7
Transfer Speed
(bps)
ON
ON
ON
2400
OFF
ON
ON
4800
ON
OFF
ON
9600*1
OFF
OFF
ON
19200*2
ON
ON OFF
38400
OFF
ON
OFF
57600
ON
OFF
OFF
115200
OFF
OFF
OFF
(Reserved)
JP1
JP2
Details
1-2
1-2
Use this setting if you are connecting and using both the TM printer and
this device.
(Default Setting)
2-3
2-3
Use this setting if you are using the DM-D stand in a stand-alone
configuration without connecting a TM printer.