DCS Use & Care Guide - Manual (Page 22)

20
Radiant tray
RADIANT ASSSEMBLY INSTALLATION:
1 . Unpack ceramic rods and remove radiant (Fig. 21) from the unit.
2 . Unlock radiant end cap by pushing it up with two fingers (Fig. 22).
3. Place 18 ceramic rods on the radiant (Fig. 23).
4. Lock radiant end cap (Fig. 24).
5. Place the assembled radiant in the unit (Fig. 25).
Note:
In case a ceramic rod breaks:
a) Unlock radiant end cap by pushing it up with two fingers (Fig. 22) or pliers may be used.
b) Replace broken ceramic rod.
c) Lock radiant end cap.
Before assembling the Radiant assembly check that the radiant
trays have not moved during transit. They should sit securely on
their locating pins in the base of the grill.
INSTALLATION
RADIANT ASSEMBLY
FIG. 21
FIG. 22
FIG. 23
FIG. 24
FIG. 25