Fisher & Paykel Series 9 Contemporary Series 24 Inch Single Convection Speed Electric Wall Oven Installation Guide - Cavity Trim Kit - Manual

COMPANION PRODUCTS
18 7/8" (480mm) CAVITY TRIM KIT
NZ AU GB IE US CA
Keep this document handy for easy reference.
● ●
This Cavity Trim Kit is designed to complement your companion product if installing into 18 7/8" (480mm) high cabinetry.
● ●
For contact information or if you require service, assistance or replacement parts, see your ‘Service & warranty’ booklet.
SECURE THE SUPPORT BRACKETS IN THE CAVITY
1 Place the two support brackets into the cabinetry with the flat side
to the outside ( A ).
2 Align the front alignment tab with the front edge of the cabinetry
( B ) with the bracket hard up to the side wall ( C ).
3 Attach the bracket to the cabinetry with the supplied self tapping
wood screws. You have the option:
● ●
of screwing down into the base of the cabinet ( D ), or
● ●
if the brackets are going to be installed above another product
then the brackets can be screwed horizontally into the side of
the cabinet (
E ).
591779A 02.19
SCREW THE TRIM ONTO THE CABINETRY
4 Ensure the front trim is correctly orientated ( F ) (ie the vents are
pointing downwards) and loosely attach it to the support brackets
with the supplied M4 machine screws.
Do not tighten .
5 Move the front trim sideways to center it within the cabinetry.
Tighten the screws to fix securely in place ( G ).
6 Install companion product ( H ) as directed in installation instructions.
A
B
D
E
Support
bracket
F
Cabinetry carcass Panel below
appliance
Panel above
appliance
C
G
H
INSTALLATION GUIDE