Cleaning and maintenance – haier HPIMD25B User Manual

Page 9

Advertising
background image

8

English

6. During the operation process, if the level of the water in the reservoir becomes

to low, the “Add Water” LED indicator will display.

NOTE: If for any reason such as water shortage, to much ice, power off, etc.,

do NOT restart the machine right away. Wait at least 3 minutes before

attempting to restart.

7. The ice maker automatically stops producing ice when the ice storage

compartment is full. The “Ice Full” LED indicator will light as confirmation.

NOTE: As a safety precaution, the auger inside the ice storage compartment and

dispensing will automatically stop working if the transparent hatch on top

of the unit is even partially open.

WARNING: Do NOT attempt in any way to disable the safety switch activator on

the transparent hatch or inside the ice storage compartment.

8. To dispense the ice, push forward on the ice cube dispenser paddle. That will

activate the auger inside the ice storage compartment, first back, then forward

and allow ice cubes to drop down the shoot. The blue overhead light should

also come on when paddle is pushed forward.

NOTE: Transparent hatch on top of the unit must be closed fully for auger to

operate and ice to dispense.

WARNING:

• Never clean the ice maker unless the power is OFF and unit is

unplugged.

• Full strength solvents, detergents, and abrasives must never be used

for cleaning.

• Never tilt or place the icemaker on its side, otherwise you must wait 2

hours for compressor coolant to settle.

It is recommended that the appliance is cleaned once a month or more frequently

in areas where chalky deposits can be a problem. A recommended cleaning

solution is 1 part vinegar to 10 parts water. The appliance should be allowed to

complete one ice making cycle, thoroughly rinsed with fresh water and dried with

a soft cloth. Any residual vinegar may cause the next ice cubes to be soft or slushy.

If this happens, the unit should be rinsed again with fresh water.

Before using your ice maker, it is strongly recommended to

clean it thoroughly
1. Power should be off and unit unplugged
2. Clean the interior with diluted vinegar solution, warm water and a soft cloth
3. Use water to rinse the interior and remove water thru the drain by removing the

drain cap.

4. It is suggested to change the water in the reservoir daily for optimum hygiene.

ClEANING AND MAINTENANCE

Advertising
This manual is related to the following products: