Honeywell HRHD 410 - Manual (Page 46)

Configuration
Rev 3.01 28 Document 900.0315
10/05
Highlight the box beside SNTP Server and then press # . Change the numbers by
highlighting them and using the Up and Down arrows to increase or decrease the
number value.
Highlight the box beside Interval and then press # . Set the time interval for
synchronization from 30 to 300 minutes.
The box beside System Clock displays the DVR time setting.
The box beside Server Clock displays the time setting of the time server. Highlighting
the Update button and then pressing # updates the server clock.
Note The Server Clock displays "–" when the DVR cannot load the time
information from the time server.
The box beside Next Synchronization displays the time when the next synchronization
is scheduled. If you want to synchronize the time instantly, highlight the Now… button
and then press # .
Caution When selecting Now…, any video with a later time and date will
be lost if the time and date of a time server is earlier than the last
recorded image of the DVR.
Note When the time difference between the DVR and the time server is
more than one minutes, the DVR might not synchronize the time
to prevent any unexpected loss of recorded video data. If you
want to synchronize the time manually, select Now… .
Highlight the Run as Server box and then press # to toggle between On and Off. When
it is On, the DVR you are setting up runs as a time server.
To save your changes, highlight OK and then press # . Select Cancel to exit the screen
without saving the changes.
Highlight the box beside Date Format and press # . A list of date formats displays.
Highlight the format you wish to use and then press # . The choices are:
MM-DD-YYYY
DD-MM-YYYY
YYYY-MM-DD
MM/DD/YYYY
DD/MM/YYYY
YYYY/MM/DD