Home Dynamix ANEXX A - Manual (Page 173)

4 Ports 11g Wireless ADSL2/2+ Router 166
9. Testing LAN path to your 4 Ports 11g Wireless ADSL2/2+ Router.
Ans. To verify whether the LAN path from your PC to your 4 Ports 11g Wireless ADSL2/2+ Router is properly
connected, you can “Ping” the 4 Ports 11g Wireless ADSL2/2+ Router with the following procedures:
1. From the Windows toolbar, click “Start” and select “Run”.
2. In the open field, type “Ping 192.168.1.1” and click “OK”
3. If the path is working, you should see the message in the following format:
Reply from 192.168.1.1 bytes = 32 time < 10ms TTL = 60
4. If the path is not working, you should see the following message:
Request timed out
If the path is not functioning correctly:
1. Make sure the LAN port LED indicator is on.
2. Check whether you are using the correct LAN cable.
3. Check your Ethernet Adaptor installation and configurations.
4. Verify that the IP address for your 4 Ports 11g Wireless ADSL2/2+ Router and your workstation are
correct and that the addresses are on the same subnet.
10. Failed to connect with the 4 Ports 11g Wireless ADSL2/2+ Router via Wireless LAN card.
Ans. Ensure that the WL ACT LED indicator of the 4 Ports 11g Wireless ADSL2/2+ Router is correctly
illuminated.
1. Check whether your Wireless LAN setting (e.g. SSID, Channel Number) is the same as your 4
Ports 11g Wireless ADSL2/2+ Router.
2. Check whether you’d used the same WEP Key Encryption for both your Wireless LAN and your 4
Ports 11g Wireless ADSL2/2+ Router.