HP C100/110 User Manual
Page 139
123
Changing Your Workstation’s Hardware Configuration
Installing Storage Devices
Storage Device Cable Routing
When you install your storage device, be aware of the suggested cable rout-
ing paths as indicated in the cable routing label that is affixed to the top of
the storage tray.
Disk Shield
If you are installing a hard disk manufactured by Hewlett-Packard, you need
to install a disk shield.
1
Check the manufacturer’s labeling on the disk drive to determine if it is a
disk manufactured by Hewlett-Packard.
If the disk is not a Hewlett-Packard disk, skip the rest of this procedure.
2
From the accessory hardware kit which came with your workstation, lo-
cate the disk shield and four screws. See Figure 23.
3
Use the four screws to mount the disk shield on the drive, as shown in Figure 23.
Figure 23
Mounting the Disk Shield