Haan FS-30P+ - Manual (Page 10)

Using Your Floor Sanitizer
pg 8 877-HAAN DIRECT / 877-422-6347 www. HAANUSA.com
1) Remove all parts from the packaging.
2) Assemble the unit as described on page 6.
3) IMPORTANT: Make sure you remove the clear
plastic film that is over the Thermal Indicator on
the water tank cap. Failure to do this could inhibit
the sensor and give an incorrect reading. DO NOT
remove the black sensor (Fig 1).
4) Place the Floor Sanitizer on the black Floor
Protector/Resting Mat (be sure the “bumpy” side
is facing up), and open the tank filling cap.
5) Using the provided fill cup, pour no more than
one Fill Cup of water (as indicated by the fill line
on the cup) into the tank (Fig 2). Do not overfill.
There is a gray bar (Water Level Indicator) just
inside the opening of the Water Tank to show the
correct water level (Fig 3). Replace the cap when
water is level to the bar and tank is filled.
6) Plug the Floor Sanitizer into a standard 120-volt
grounded wall receptacle.
7) Press the Burgundy ON/OFF power button to turn
your Floor Sanitizer ON. The GREEN Power ON
light will illuminate (Fig 4).
NOTE: The Burgundy button can sometimes be
confused as a release for the handle/pole of the
Pet Plus™. The Burgundy button is the POWER button
only. To release the handle/pole, simply place
your foot gently on top of the Pet Plus™ and pull back.
Your Pet Plus™ is ready to use when the Thermal
Indicator on the tank cap changes from black to
orange.
8) Place a cleaning pad on the floor with the ‘hook
& loop’ side facing up. Lightly press the base of
the Pet Plus™ on the pad, making sure the cleaning
pad is centrally positioned to the bottom of the
unit. The specially-designed bottom of the Pet
Plus™ will grip the pad.
DO NOT attach the pad crossways to the bottom
of the unit (Fig 5a & 5b).
Operating Instructions:
Fig 1
Fig 2
Fig 5
Fig 3
b)
a)
Fig 4
Remove
film
Water Level
Indicator
GREEN
Power
Light
ON/OFF
Button
Yes
NO!