Horizon Fitness CT61 - Manual (Page 5)

DO NOT CUT STRAPS UNTIL STEP 1-E!*
Disassemble box and remove the
cardboard packaging that is not beneath the treadmill. Do not attempt to lift the
treadmill at this time. Remove plastic wrap from console masts.
NOTE:
It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to
prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
8
ASSEMBLY STEP 2
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL OPERA
TION
LIMITED
W
ARRANTY
7
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
* Be sure to tighten bolts after all are lined up.
BOLT (B)
LOCK
WASHER (C)
ARC WASHER (D)
ARC WASHER (D)
CONSOLE CABLE
DO NOT ATTACH
THIS SIDE UNTIL STEP 2-F
ASSEMBLED IN STEP 2-D
��������
�����
������
����������
���������������
������
��������������
������
HARDWARE BAG FOR STEP 2 CONTENTS :
PRE-ASSEMBLY
WARNING
ASSEMBLY STEP 1
1
3
2
��������
�������
������
HARDWARE BAG FOR STEP 1 CONTENTS :
LEFT CONSOLE MAST
LEFT SIDE LINKAGE ARM
BOLT A
* NOTE: If the straps have been removed before completing step 1-D and the linkage arms can not be aligned,
refer to the TROUBLESHOOTING section (page 26) in order to restore the treadmill to its proper position.
A Open HARDWARE BAG FOR STEP 1.
B Lift LEFT CONSOLE MAST into
upright position. Be sure to hold
the console mast firmly, as it will
not stay in the upright
position on it’s own.
C Move LEFT SIDE LINKAGE ARM
into position. Insert BOLT (A) and
tighten.
D Repeat on the right side.
E Now cut the banding straps and
remove remaining packaging
material.*
F Lift the RUNNING DECK until lock
latch on side of treadmill is fully
engaged.
G Remove CONSOLE from box
and place out of the way.
H Lower the treadmill RUNNING
DECK from the folded position by
stepping on LOCK LATCH on lower
right side.
A Open HARDWARE BAG FOR
STEP 2.
B With running deck in lowered
position, place CONSOLE
on upright masts. Slide the
brackets that are underneath
the console into the top holes of
the upright masts.
C Place LOCK WASHER (C) and
BOLT (B) into flat side of
LEFT upright MAST and lightly
tighten.
D Place ARC WASHER (D) and
BOLT (B) into curved side of
LEFT upright MAST and lightly
tighten.
E Gently lift RIGHT side of
the console to connect the
CONSOLE CABLE. Carefully tuck
wires in mast to avoid damage.
NOTE: Do not pinch console
cable or grip pulse wires.
F Repeat steps C-D above to
assemble the right side upright
mast and console.
G Tighten all bolts completely.
CT61 Treadmill Rev 1.3.indd 8-9 5/31/05 1:55:14 PM