HP Model 743 PC - Manual (Page 71)

3-7
Typical Installation in a VME Card Cage
Board Computer Installation
Figure 3-1 Board Computer Captive Screws
Installing a Dual-Slot Model 743
1 Put the board computer at the desired slot. Position and slide it into the
card cage until it seats properly with the front panel and front panel exten-
sion flush against the card cage.
2 Engage all captive screws (labeled 1 and 2, 3 and 4, in Figure 3-1) before
tightening each screw of the board computer and the extension panel(s).
3
1 2
4