Recording settings, Record screen – Honeywell HRSD16 User Manual
Page 71
Configuration
Document 800-00918
Rev F
71
02/08
2.
Highlight the field beside Port and select from None, RS-232C, and RS485. If the
RS-232C port and RS485 port are in use for PTZ control, networking, or text input,
the remote keyboard cannot be configured.
3.
Highlight Setup… and select the correct Baud Rate, Parity, Data Bits and Stop
Bits for the device you are connecting to the DVR.
4.
Highlight the field beside Remote Control Product and select the device from the
list.
Save your Remote Control settings by highlighting Save and pressing
. Select
Cancel to exit the screen without saving the changes.
Recording Settings
Your DVR offers a variety of flexible recording modes. You can set it to:
•
record all the time
•
record only events
•
continue recording once the hard disk drive is full by recording over the oldest
video
•
stop recording and alert you when the hard disk is full
Figure 3-45
Record Menu
Record Screen
Highlight Record in the Record menu and press
. The Record setup screen
appears.
Figure 3-46
Record Setup Screen