Honeywell HCM-6009 - Manual (Page 7)

7
EasySet ™ Control Operation (Model HCM-6013i) (Continued)
S T E P 2 : O U T P U T / F A N S P E E D C O N T R O L
Your unit has three output levels/fan speeds:
HIGH: For fast humidifying
MED: For everyday moisture control
LOW: For minimum operation (ideal for nighttime use)
• Push the up button ( +) to increase output level and push the
down button ( –) to decrease output level. The LED's will
illuminate to reflect which speed you have selected (Fig. 8).
Continuous Mode: If you want your unit to run continuously,
select a fan speed level. (Do not set your humidistat.) It will
run at your selected speed until you shut it off or it runs out
of water.
NOTE: Turn the humidifier off if the humidity level feels too
moist or you notice condensation forming on the walls.
S T E P 3 : S E T H U M I D I T Y
• Set your desired humidity anywhere between 35% and 55%.
• Push the up button ( +) to increase desired humidity and push the
down button ( –) to decrease desired humidity. The LED's will
illuminate to reflect which desired humidity level you have
selected (Fig. 9).
For example: If you set your humidity at 40%, the 35% and 40%
LED’s will be illuminated.
• Once you have set your desired humidity, the unit will operate
under this setting until the unit is turned off or your selected
humidity is reached.
• When the desired room humidity has been reached the fan will automatically shut off. (The humidity
LED's will remain illuminated)
• The fan will turn back on when your room decreases beyond your set level.
NOTE: Your room humidity can often fluctuate. It is normal for your unit to turn itself on and off
throughout the day as it is monitoring your changing environment.
To go back to Continuous Mode, turn your unit off and then back on and select your desired output setting
(see Step 2).
I O N I Z E R F E A T U R E
The ionizer helps freshen the air.
• Press the Ionizer button once to start; the Ionizer light will illuminate. Note: The unit must be turned on
for the Ionizer to function.
• To turn off the ionizer, simply press the ionizer button again; the ionizer light will turn off.
NOTE: The ionizer automatically turns off when the desired humidity is reached (your desired humidity
light will be illuminated, see Fig. 7). It will turn back on again when your humidifier restarts.
Fig. 8
Fig. 9
QuietCare_Console_OM_Rev1.qx 8/25/06 1:32 PM Page 7