HP PN1050 - Manual (Page 26)

ENWW TCP/IP Configuration 26
TCP/IP Main
host-name:
(sys-name:, name:)
Specifies the node name. Default is NPIxxxxxx, where xxxxxx is the last six digits
of the LAN hardware address.
domain-name:
The domain name for the device (for example, support.hp.com). It does not
include the host name; it is not the Fully Qualified Domain Name (such as
projector1.support.hp.com).
pri-dns-svr:
(dns-srv)
The IP address of the DNS (Domain Name System) server.
sec-dns-svr:
The IP address of a secondary DNS server to use if the primary DNS server is
unavailable.
pri-wins-svr:
(pri-wins-srv:)
The IP address of the primary Windows Internet Naming Service (WINS) server.
sec-wins-svr:
(sec-wins-srv:)
The IP address of the secondary Windows Internet Naming Service (WINS) server.
TCP/IP Access Control
allow: netnum [mask]
Makes an entry into the host access list stored on the HP Jetdirect projector server.
Each entry specifies a host or network of hosts that are allowed to connect to the
projector. The format is “allow: netnum [mask]” where netnum is a network number
or host IP address, and mask is an address mask of bits applied to the network
number and host address to verify access. Up to 10 access list entries are allowed.
If there are no entries, all hosts are permitted access. For example,
allow: 192.0.0.0 255.0.0.0 allows hosts on network 192.
allow: 192.168.1.2 allows a single host. In this case, the default mask
255.255.255.255 is assumed and is not required.
allow: 0 This entry clears the host access list.
For additional information, see Chapter 5 .
Table 3.3 TFTP Configuration File Parameters (2 of 7)