HP ML100 - Manual (Page 29)

o Extend the server from the rack.
4.
on, see the server installation sheet on the HP website
Remove the access panel (on page 7).
5. Remove the air baffle.
For more informati
(http://www.hp.com/go/bizsupport).
6. Open the DIMM slot latches.
7. Install the DIMM.
9.
10.
back into the rack.
ll the tower bezel, as needed.
onfigure this mode in RBSU ("ROM-Based Setup
ooting failed DIMMs, see the server installation sheet on
the HP website (http://www.hp.com/go/bizsupport).
Expansion board options
For server s with
8. Install the air baffle.
Install the access panel.
For ML110 G6 servers, slide the server
11. For ML150 G6 servers, do one of the following:
o Close or insta
o Slide the server back into the rack.
If you are installing DIMMs in lock-step configuration, c
Utility" on page 38).
For more information about LEDs and troublesh
-specific expansion board installation instructions, refer to the installation sheet that ship
the server.
CAUTION: To prevent damage to the server or expansion boards, power down the server
alling the expansion boards. and remove all AC power cords before removing or inst
To install the component:
1.
2.
rver from the rack.
Power down the server (on page 7).
For ML110 G6 servers, extend the se
Hardware options installation 29