HP 480-0005-00-15 - Manual (Page 29)

P/N 480-0005-00-15 2-5
Chapter 2: Hardware Components
Front (with DC Power)
NOTE: For pictorial purposes, Figure 2-3 shows the unit with 1 DS1 card and the CPU card.
Figure 2-3 Tenor CMS Front View - DC unit
• Card Slots. Fourteen slots are available for WAN cards (T1/E1/DS1), DSP cards, and the CPU/System
Controller card.
• Power Supplies. Two load-sharing DC power supplies. The load sharing feature enables one power sup-
ply to take over if the other fails.
• System Fans. Two system fans, accessible through a swing down panel via thumb screws, are used to
cool the chassis. These fans are “hot-swappable”, meaning you can remove/replace the fans while the
unit is operational.
• Reset Button. Enables you to reset the system. This function will be supported in a future release.
• Ground Strap Socket. A ground connection is provided for ESD protection.
• Air Filter. The Air Filter is accessible by opening the lower front panel. You do not have to turn off the
chassis. For cleaning, see Chapter 8: Diagnostics/Maintenance.
• Chassis LEDs. The LEDs are indicators as to the status of the four voltage supplies. When these are lit,
they indicate the respective voltages are being output from the power supplies. When unlit, the voltage is
not being supplied. See Chapter 8: Diagnostics/Maintenance for more information.
0 1
Reset +3.3V +5V +12V -12V
Q UINTUM
T ECHNOLOGIES, INC.
TM
Q UINTUM
T ECHNOLOGIES, INC.
TM TM
Fault Fault
TM
Ground
Strap
Status Alarm
CPU PCI
Reset
10/100 Ethernet
Link TX/RX
1
2
3
4
Q UINTUM TM
TECHNOLOGIES, INC.
Hot Swap
CPU
Hot Swap
DS1
Status Alarm
1 2
PCI CPU
Bank DSP
1
2
TX/RX Link
1
2
3
4
5
6
7
8
10/100 Ethernet
Span Status
TECHNOLOGIES, INC.
Q UINTUM TM
Ground Strap Socket
Air Inlet
Reset
Button
Chassis LEDs
System Fans
Power
Supplies
Card Slots
Air Filter