HONDA Outboard Motor BF135A - Manual (Page 77)

2.5 lbf·ft (3.4 N·m , 0.35 kgf·m)
75
SERVICING YOUR OUTBOARD MOTOR
WATER
SEPARATOR
CUP
SUSPENSION
STRAP
CUP
O-RING
SUSPENSION
STRAP
WATER
SEPARATOR
CUP
WATER
SEPARATOR
WATER SEPARATOR
BRACKET
ALIGNMENT
POSION
Squeeze and release the priming
bulb to fill the vapor separator, and
check for leaks.
If the buzzer sounds or water or
sediment accumulation are found to
be caused by excessive water or
sediment accumulation in the fuel
filter, inspect the fuel tank.
Clean the fuel tank and tank filter if
necessary. It may be necessary to
drain the fuel tank completely and
refill with fresh gasoline.
Reassemble the water separator
body and the cup.
TIGHTENING TORQUE:
Thoroughly clean the water
separator cup.
Remove the three screws and
separate the water separator cup
from the body. Align the center of suspension
strap with the screw position and
install the water separator
assembly.
Reinstall the water separator in the
reverse order of removal.
9.
8.
7.
6.
5.
4.
04/01/21 11:20:39 31ZY6600_076