Attaching the neck strap, Installing the batteries – HP PhotoSmart 945 User Manual
Page 16
16
HP Photosmart 945 User’s Manual
Attaching the Neck Strap
Insert one end of the neck strap through
a neck strap mount. Then thread the
neck strap through the plastic tab to
secure it.
Repeat to attach the other end of the
neck strap to the other neck strap
mount.
Installing the Batteries
1
With the front of the camera facing
you, open the battery door on the
bottom of the camera by sliding the
latch to the “unlock” (
) position
and pulling the door toward you.
2
Insert the batteries as indicated
inside the door.
3
Close the battery door by pushing the
door toward the back of the camera and
sliding the latch to the “lock” (
)
position.
NOTE
Digital cameras use batteries at a
much faster rate than film cameras.
Battery life in digital cameras can be
measured in minutes and hours of use
rather than the years more typical of film cameras. Battery
life may vary dramatically from one user to another,
depending on what modes the camera is being used in
most frequently. Battery life will also vary dramatically
depending upon the type of batteries installed in the
camera. For hints on optimizing battery performance, see